|
|
Post by niksan29 on Aug 15, 2019 7:44:05 GMT
Hello! All your updates are for the default scenery, but the big problem with the default scenery is the incorrect elevation....  How difficult is it to make a separate update for airport heights according to navigraph data?  |
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on Aug 28, 2019 18:05:07 GMT
Hello! All your updates are for the default scenery, but the big problem with the default scenery is the incorrect elevation.... How difficult is it to make a separate update for airport heights according to navigraph data? The problem there is that the default data is set for the default Flight sim mesh i believe ...if you change the default airport elevations you could end up with Airports on a cliff/plateau or high up/low down in the terrain etc it would also be very time consuming checking each one ..it is possible but hard work getting it to look right, its best to use an add on Airport for the one you want as the Designers would build their airports to take into account their own mesh amd terrain etc .
Rich
|
|
|
|
Post by niksan29 on Aug 28, 2019 19:33:09 GMT
Yes, I know this, but for example there is a free mesh 2,0 of the whole world, you can focus on this data;)
|
|
|
|
Post by Herve Sors on Aug 29, 2019 11:53:56 GMT
Not everybody is using such mesh data..many (most) still use default FS/P3D data at least for airports for which they didn't install a dedicated scenery. It is quite impossible to offer a different set of data without a complete rework of all BGL files. Now, my personal opinion is that some inaccuracies in airport elevation (that usually do not exceed a few tenths of feet at least for existing airports that were not moved away) is a bit anecdotal and does not preclude accurate approaches using updated nav data, with indeed possible small differences in DA (but not DH) for precision and non-precision approaches
My 2 cents
Hervé
|
|
|
|
Post by niksan29 on Aug 30, 2019 8:43:02 GMT
It is quite impossible to offer a different set of data without a complete rework of all BGL files. If it’s so complicated, then of course it’s not worth it, I understand, thanks! |
|
